4-4
The Stinger® Compact Remote ATM DSLAM Getting Started Guide
Initial Stand-alone Configuration
Administrative connections
Figure 4-3. Gigabit Ethernet connection
To connect a management workstation to the Stinger CR ATM DSLAM unit using an
indirect Ethernet connection:
1
Connect the optical fiber to the Gigabit Ethernet port on the IP2000 module.
2
Connect the other end of the optical fiber to an optical switch that provides access to the
management network.
3
Ensure that the management workstation has connectivity to the management network on
which the unit resides.
4
Ensure the Ethernet transceivers are connected properly to the network.
Modem connection to a workstation console
The STGR-CM-B control module is equipped with an internal modem. This modem is
configured by default to automatically answer any incoming calls. For this reason,
you need only connect a standard analog telephone line to the RJ-11 jack on the face
of the control module. Figure 4-4 shows the Compact Remote ATM DSLAM jumper
connection for the internal modem.
LPM 1
LIM 1
LPM 2
LIM 2
LPM 3
LIM 3
COP
LPM 1
LIM 1
LPM 2
LIM 2
LPM 3
LIM 3
COP
COMP
COMPACT R
EMO
CT REMOTE
TE
COOLING UNIT
COOLING UNIT
ST
STATUS
TUS
INTERNAL
INTERNAL
EXTERNAL
EXTERNAL
RED - F
RED - FAUL
ULT
GREEN - A
GREEN - ACTIV
E
CTIVE
BLINKING GRE
EN - INITIALIZIN
G
BLINKING GREEN - INITIALIZING
COMP
COMPACT R
EMO
CT REMOTE
PO
TE POWER
SUPPL
WER SUPPL
Y
V.CHECK
.CHECK
-48V
-48V
0V
0V
STATUS
POWER INPUTS
WER INPUTS
-190V
-190V
+190V
+190V
LINK
ACT
10
100
ACT
LINK
Gig. E
Gigabit
Ethernet port
Workstation
Ethernet port
LINK
ACT
10
100
ACT
LINK
Gig. E
IP network
Optical
switch/router