Lucent Technologies STGR-LIM-VD-24, Руководство пользователя, Страница: 94 / 102

............................................................................................................................................................................................................................................................
Checking status of the physical interface Checking interface status
7 - 4 363-217-032R9.9.0
Issue 2, March 2006
............................................................................................................................................................................................................................................................
Checking status of the physical interface
Introduction
The
physical-status
subprofile provides information about the physical interface.
Bit-error-rate-test results
The interface runs a continuous bit-error-rate test (BERT) over its unused bandwidth, so
bit-error counts are always available without explicitly running a BERT and disrupting
data transmission. Integrated BERT results are displayed by the
accum-bit-err
,
num-
sec-valid
, and
num-sec-invalid
parameters.
Physical-status subprofile example
Following are the Physical-Status subprofile parameters shown with sample settings for an
active interface:
[in AL-DMT-STAT/{ shelf-1 slot-3 4 }:physical-status]
if-group-index = 0
unit-type = coe
dev-line-state = port-up
up-stream-rate-fast = 32736
down-stream-rate-fast = 65824
up-stream-rate-interleave = 0
down-stream-rate-interleave = 0
up-stream-latency = fast
down-stream-latency = fast
firmware-ver = 1.0.1rIK004010
ansi-adsl-ver = 13
initial-adsl-ver = 0
hardware-ver = 19
modem-hw-state = init-ok
accum-bit-err = 0
num-sec-valid = 0
num-sec-invalid = 0
operational-mode = vdsl
last-state-change = { { 12 10 17 } { Thursday October 2005 27
} }
Physical-status details
Parameter Setting
if-group-index
Indicates the SNMP interface group index of the line.
unit-type
Indicates the operating mode (should always be COE).