Lucent Technologies STGR-LIM-VD-24, Руководство пользователя

Страница: 48 / 102

............................................................................................................................................................................................................................................................
Delay parameters The AL-DMT subprofiles
3 - 1 8 363-217-032R9.9.0
Issue 2, Mrach 2006
............................................................................................................................................................................................................................................................
Delay parameters
Introduction
Data interleaving increases the ability of the system to tolerate noise on the line.
Additionally, it increases the latency (delay) of the data traffic.
Default settings
Following are the Interleave-Path-Config subprofile parameters, shown with default
values for specifying the maximum tolerable delay for interleaver/deinterleaver
operations:
[in AL-DMT/{ any-shelf any-slot 0 }:interleave-path-config]
max-delay-up = 16
max-delay-down = 16
min-inp-down = auto
min-in-up = auto
Parameter descriptions
Parameter Setting
max-delay-up
Specifies the maximum milliseconds of delay allowed in the
upstream direction, as a result of interleaving data. The valid range is
0 through 64.
The default value is 16 milliseconds.
max-delay-down
Specifies the maximum milliseconds of delay allowed in the
downstream direction as a result of interleaving data. The valid
range is 0 through 64.
The default value is 16 milliseconds.