Lucent Technologies PARTNER Advanced Communications System Release 1.0, Инструкция по программированию и эксплуатации

Страница: 109 / 365

For PBX or Centrex systems that require a dial-out code to make calls
outside the PBX or Centrex system, include the dial-out code followed by
one or more pauses (if available) on an Auto Dial button for a number
outside the PBX or Centrex system. (See “Changing Settings to Support
PBX or Centrex Services” in Chapter 2 for more information.)
Examples
The examples below show some possible entries for an Auto Dial number in Step
4 of “Programming.”
Outside Phone Number. Enter the phone number (up to 28 digits) exactly
as you would dial it. For example, to program 555-2398, press 5 5 5 2
3 9 8 .
Extension Number. Press the left i button and enter the two-digit
extension number. Press * before the extension number to program the
Auto Dial button to voice signal an extension. For example, to program
extension 20 for voice signaling, press
i * 2 0 . The display reads:
Intercom *20
Feature Code. Enter the appropriate code. For example, to program a
button to turn on the message light at extension 20, press f 0 9 2
0 . When you press the programmed button, the Message Light at
extension 20 turns on.
Programming
(See Figure 2-3 in Chapter 2 for the location of special programming buttons
such as
s
and
e
on system phones.)
To program an Auto Dial button:
1. Press
f 0 0 s s c
at extension 10
or 11.
2. Enter the number of the extension to be programmed.
3. Press a programmable button.
4. Enter an outside phone number, feature code, account code, or PBX/Centrex
feature access code; or press left
i
and enter an extension number.
5. Repeat Steps 3 and 4 to program additional Auto Dial buttons, or exit
programming mode.
5-16
Auto Dialing