Lucent Technologies Orinoco WavePOINT II, Руководство по началу работы

Страница: 28 / 66

ORINOCO WavePOINT-II - Getting Started 2-9
Installing the WavePOINT-II AP - Hardware Installation
!
CAUTION:
Before you proceed:
Verify that all four recesses are fitted correctly onto the
corresponding tabs of the mounting plate. If the processor module is
not properly seated, it may drop causing severe personal injury and/
or causing serious damage to the ORiNOCO WavePOINT-II AP
unit.
Connecting the Network Interfaces 2
One PC Card slot of the ORiNOCO WavePOINT-II AP is equipped with a
plastic Slot Protector Card. The purpose of this card is to protect the
WavePOINT-II AP unit from dust when the access point is used with a single
ORiNOCO network interface only.
When you intend to install two ORiNOCO network interfaces into your
access point, first take out the Slot Protector Card. You are advised to keep
the Slot Protector Card for situations when you would like to change the
WavePOINT-II AP hardware configuration in the future.