Lucent Technologies MERLIN LEGEND Reporter, Инструкция по установке и эксплуатации

Страница: 54 / 159

System Management
Issue 1 January 1997
3-15
Facility. The identifier (up to 15 characters) for a group of lines that carry calls
requiring similar services — typically, these line groupings are already programmed for
your telephone system.
For example, if you have a pool of Central Office lines, you may call the facility
“CO” and associate the lines in that pool under this name. Other examples are:
“Private” (private lines), “WATS” or “IN-WATS” (for 800-number service lines),
“ICLID” (for lines with “Caller ID” service).
Outgoing and Incoming Carrier Services. These are internal values, always set to
“Default Outgoing” and “Default Incoming.”
Target Grade of Service (GOS). The desired probability (0.0 to 20.0 %; default = 2.0
%) of receiving a busy signal during the facility busy hour. The system uses actual
traffic data to estimate the number of lines required to meet this value.
Number of Lines (if enabled). The number of physical lines in this facility.
Delete at end of Accounting Period. Select [x] to remove this facility from the system
table when the period ends.
Summary of Procedures (Lines and Facilities )
1. Select Line from the Configuration menu.
2. For additions, select Add; for changes, select the desired entry and use Delete or
Edit, as appropriate.
If Delete is disabled, it means that this entry is in use elsewhere in the
database. Use Edit and select [x] Delete at End of Accounting Period.
3. For additions or edits, complete the dialog box.
4. To set up a facility and/or change its attributes, use the Facilities button:
a. For additions, select Add; for changes, select the desired entry and use Delete
or Edit, as appropriate.
If Delete is disabled, it means that this entry is in use elsewhere in the
database. Use Edit and select [x] Delete at End of Accounting Period.
b. For additions or edits, complete the dialog box and select Apply (Reset
cancels). You may work with another entry or select Close to exit.
5. Back at the Line dialog box, you may assign the newly-created facility via the Edit
button.
6. When complete, select Apply (Reset cancels). Use Close to exit.
See Site
Selection in
Chapter 8.