Lucent Technologies MERLIN LEGEND Release 7.0, Руководство по системному программированию, Страница: 145 / 1082

MERLIN LEGEND Communications System Release 7.0
System Programming
555-670-111
Issue 1
April 1999
Programming with SPM
2-19 Accessing SPM
2
Local or Remote Modem Connection
2
The method you use to access SPM by modem depends on whether you are
programming onsite (locally) or from a remote location.
■
If you are onsite, the modem must be connected to a T/R jack on an
012 (T/R) or 016 (T/R) module, or to a jack that has been programmed for
T/R on a 412 LS-ID-ETR or 016 ETR module on the control unit. To
establish a connection to the control unit’s internal modem, dial
*10
.
■
If you are at a remote location, do either of the following:
— Place a call to the system on a Remote Access line, enter the barrier
code (if required), and dial the code for the internal modem (
*10
).
— Place a voice call to the system using the line to which the modem is
connected and ask the operator to transfer you to the modem (press
Transfer, dial
*10,
then hang up the telephone). When you hear the
modem answer tone, switch to data mode.
Considerations
2
Review the following items before you begin the modem connection procedure.
Set the Programming Language 2
If you prefer to program in a language other than the current SPM language
setting, see
‘‘Language’’ on page 2-42 .
Modem Connections
2
You must make a data connection to a modem. The following modem dialing
commands are for Hayes
®
and Hayes-compatible modems. These may not be the
commands your modem uses; refer to the user guide that came with your modem
for specific information.
■
If the PC is in the same location as the control unit, type
*10
.
■
If the PC is in a remote location and your system has the Remote Access
feature activated, type the following and press
1
:
— Without barrier codes, type:
ATDT
; the remote access telephone number; and
W*10
.
For example:
ATDT12015551234 W*10
1
.
— With barrier codes, type:
ATDT
; the remote access telephone number; and the barrier code
preceded by a “
W
” and
W*10
. The barrier code in the example below
is 555555.
For example:
ATDT12015551234 W555555 W*10
1
.