MERLIN LEGEND Communications System Release 5.0
Feature Reference
555-650-110
Issue 1
June 1997
Features
Page 511
Recall/Timed Flash
Recall/Timed Flash
3
7
At a Glance
3
7
Description
3
7
Recall sends a momentary signal called a
timed flash
or
switchhook flash
while
the phone is on the hook. A timed flash is used as a control signal, as follows:
■
On an inside call, the signal is intercepted by the control unit.
— A multiline telephone user can use Recall to disconnect a call and get a
new dial tone without hanging up. The user can be on an active call or
listening to ringback or dial tone. When the user is listening to a busy
signal, Recall has no effect.
— A single-line telephone user can use Recall to put an active call on hold
and to access system features such as Conference and Transfer.
■
On an outside call, when the system is using host switch services such as
Centrex, the signal may be sent to the host, depending on the type of
telephone and system operating mode.
■
A multiline telephone user can use Recall to access host features. The
user can be connected to another party or can be listening to outside dial
tone, ringback, or a busy signal.
■
A single-line telephone user can use Recall to access host services only if
the system is programmed for Behind Switch mode.
Users Affected
Telephone users, DLC operators
Reports Affected
Extension Information, System Information (
SysSet-up
)
Modes
All
Telephones
All except QCC
Programming Codes
Recall
Conference
Drop
Transfer
*775
*772
(Behind Switch mode only)
*773
(Behind Switch mode only)
*774
(Behind Switch mode only)
Feature Code
775
MLX Display Label
Recall [Recll]
System Programming
Change timed-flash duration (recall timer):
●
Options
→
More
→
RecallTimer
Program fixed Conference, Drop, and Transfer buttons to
access host features in Behind Switch mode:
●
Options
→
More
→
BehndSwitch
→
Conference/Drop/
Transfer
Factory Setting
Recall Timer
450 ms (options 350 ms, 450 ms, 650 ms, 1 sec)