Lucent Technologies Definity Audix System, Установка и обновление

Страница: 29 / 208

Task 5: Install the DEFINITY AUDIX System Assembly
Issue 2 December 1996
2-7
5. Insert the DEFINITY AUDIX system assembly (see Figure 2-1, DEFINITY
AUDIX System Assembly) into the switch cabinet as follows:
Holding the DEFINITY AUDIX system assembly by the outside edges of
the faceplate, line up the alarm board (ALB) and the multifunction board
(MFB) with the bottom guides of the third and fourth slots, respectively, of
the five reserved port slots in the switch carrier.
!
WARNING:
The DEFINITY AUDIX system will automatically boot when seated in
the slots. Damage to the disk could occur if the assembly is removed
while booting. Therefore, you should try to avoid the need to adjust or
reinsert the assembly after the first attempt to insert it; make sure that
the assembly is properly aligned in the slot, then insert it with a single
firm push.
6. Insert the assembly and lock it in place by pushing up the securing
latches on the two circuit packs. (It is normal for the two circuit packs to
feel loosely connected to each other. This is to allow some give when you
are seating them into the two slots of the backplane.) If the switch is
powered on, the DEFINITY AUDIX system will boot automatically.
If the switch is not powered on, wait until it is and then proceed to Step 7.
7. As the DEFINITY AUDIX system comes up, watch the LCD on the
faceplate (see Figure 2-3, DEFINITY AUDIX System LCD Display). The
LCD display identifies the states and alarms for the DEFINITY AUDIX
system.