Lucent Technologies DDM-2000 OC-3, Руководство пользователя и обслуживания

Страница: 1196 / 2536

UPD 6 of 1 Page UPD
NAME
List Equipment Update upd:
FORMAT INPUT
upd;
DESCRIPTION
!
CAUTION:
service. affect may command this of Execution
nonvolatile the in recorded (as base data system the updates command This
signals. incoming and configuration hardware existing the reflect to memory)
button, Update/Initialize the pushing by either executed be can command This
CIT. the from command the entering by or pack circuit SYSCTL the on located
the on appear will (.) dot a pushed, is button Update/Initialize the When
display. 7-segment
1: NOTE
An
upd
time any at performed be may
except
10- the during or before
while (SYSCTL) Controller System the up powering after window second
flashing. is LED (CR) critical the
2: NOTE
pack circuit SYSCTL the on light LED critical the that note should user The
system a for button Update/Initialize the pressing after flash to continue will
Do reset. not after flashing stop will light LED The command. this reenter
seconds. 10
and supported be will pack circuit LAN IMA the 15.0, Release OC-3 with Starting
shelf. OC-3 the of slots Speed Low the in allowed
to goes port LAN the pack, circuit LAN IMA the of insertion Upon auto VT a If .
to goes channel VT the created, is cross-connect auto is signal good a If .
LAN the and port, DS1 the channel, VT the cross-connect, this through received
to go interface in-service to goes VT/DS1 first the (when in-service the ,
to goes interface LAN corresponding in-service VT cross-connected the If ).
receives channel AIS VT inc. hits user the and rings both on signal
upd
VT the ,
to back go DS1 the and channel auto to goes port DS1 last the When . auto,
to goes interface LAN corresponding the then auto well. as
11-526
2000 February 2 Issue
OC-3 DDM-2000