Lucent Technologies CAJUN M770, Руководство пользователя

Страница: 123 / 266

Cajun M770 ATM Switch User’s Guide 105
Chapter 9
Managing Static Routing
This chapter describes how to use the command-line interface to setup and manage
static routes in a Cajun M770 ATM Switch. For information about how to access
and use the Cajun M770 ATM Switch command-line interface, see Chapter 3 How
to Use the Command-line Interface.
Setting up routing entries
This chapter describes the commands that allow you to configure static routes in
the routing table in the Cajun M770 ATM Switch. For more examples about setting
up routing entries for an attached device, see Routing Configuration in Chapter 2.
Static routing is needed when connecting to an ATM host which does not support
ILMI, and when connecting to another switch which supports only IISP and not
PNNI.
Adding a new routing entry to the routing table
To add a new routing entry to the routing table, enter a partial prefix, followed by
one or more virtual ports. A 19-byte ATM address is usually composed by
combining the switch network prefix with the End-Station Identifier (ESI) of the
attached device.
Note: Static routing should be configured on the module through which the route
is performed e.g. if you want to add a route to virtual port 8.4.0 you need to
configure this in module number 8.
The static routes shown in module 8 will be only the routes of module 8.