Installation Instructions
1 |
P a g e
v 1 . 0 ( 0 4 / 2 0 2 1 )
ODETTE LED TABLE LAMP
SKU# 259310, 259311
Rated Voltage 5V DC, 1A
Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all
instructions carefully before assembly, installation and use of the product. Please keep the instructions for future reference.
Warranty
•
This product is covered by a 12-months warranty. Please retain the proof of purchase.
•
Warranty will be void if there is any damage due to improper usage or modification to the product.
•
Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void the
warranty.
Installation requirements
•
Select a suitable location for the luminaire;
- Ensure it is on a flat and stable surface.
- This product is suitable for indoor use only.
- Do not place flammable material near or over the luminaire.
- Ensure the luminaire is not placed next to any air vents and is not in any moist or damp areas.
•
Take care not to pull any electrical wires during unpacking as this may damage the connection.
•
Lay out all the components on a smooth surface and make sure no components are missing before assembling.
If parts are missing, return the complete product to the place of purchase for inspection or replacement.
•
Check whether the luminaire has been damaged during transport. Do not operate/install any product which
appears damaged in any way. Return the complete product to the place of purchase for inspection, repair or
replacement.
Operation directions
Operation:
1. Remove all packaging material from the product.
2. Select a suitable location for the table lamp. See the installation requirements above.
4. Press the touch switch on the top of the luminaire to adjust the brightness of the light and turn it on/off;
- Press once, the light will be on and reach 10% of the full brightness;
- Press twice, the light will be 50% of the full brightness;
- Press third time, the light will be 100% of the full brightness;
- Press fourth time, the light will be off.
Batteries and charging:
NOTE: The luminaire includes a re-chargeable Li-Battery. The battery is non-replaceable. Do not attempt to
replace the battery. When the battery reaches its end of life, the whole luminaire shall be replaced.
To charge the luminaire, plug the provided USB cable into the charging port and connect the USB cable to a power
adaptor.
NOTE:
Please ensure an appropriate power adaptor is used for charging according to the rated input (5V DC, 1A) of
this luminaire.
