Installation Instructions
1 | P a g e
v 1 . 0 ( 0 6 / 2 0 1 8 )
PORTSEA WALL BRACKET
SKU# 239370, 239371, 239372
Rated Voltage 220-240V~ 50Hz
Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all
instructions carefully before assembly, installation and use of this product. Please keep instructions for future reference.
Warranty
•
This light fitting is covered by a 12 month warranty. The warranty is from date of purchase, not the date of installation.
•
If the fitting is not installed by a licensed electrician the warranty will be void.
•
Please retain proof of purchase and evidence of installation by a licensed electrician for any warranty claims.
•
Warranty will be void if there is any damage due to improper usage or modification to the fitting.
•
Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void the warranty.
Installation Requirements
•
Must be installed by a licensed electrician.
•
All wiring and installation of the light fitting must adhere to local and national wiring rules.
eg. AS/NZS 3000:2007/Amendment 2:2012 Electrical installations.
•
This fitting is a Class I product and must be earthed.
•
This fitting is rated IP44, this must be maintained during wiring and installation.
•
Do not exceed the maximum wattage rating.
•
Select a suitable location for installation:
−
The mounting point must be able to support 2 times the weight of the fitting.
−
This fitting is protected against water penetration to IP44 standards, which is splashing water from any direction.
•
Take care not to pull any electrical wires during unpacking as this may damage the connection.
•
Lay out all the components on a smooth surface and make sure there are no components missing before
assembling. If parts are missing, return the complete product to the place of purchase for inspection or replacement.
•
Check whether the fitting has been damaged during transport. Do not operate/install any product which appears
damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.
•
Ensure power to the circuit you are working on has been switched OFF before commencing any electrical work.
Installation Directions
1. Remove all packaging material from the product and be careful not to throw away accessories that may be hidden
within the packaging material.
2. Use the mounting bracket as a template to mark the screw positions on the wall. Drill holes into the wall. (Fig.1)
3. Install the mounting bracket on the wall by using appropriately sized mounting screws and anchors. Ensure the
screws and anchors used are suitable for the mounting surface and surrounding environment. (Fig.2)
4. Remove the terminal box cover to access the terminal block and connect the mains supply wires. (Fig.3)
Mains Supply Wire
Fitting Wires
Earth – Yellow/Green
Yellow/Green or
Neutral – Blue or Black
Blue or N
Live – Brown or Red
Brown or L
Ensure the wires are secure and no bare wires are exposed. Install the cover back onto the terminal box.
Place the terminal box in the cavity at the rear of the Frame/Body frame/body assembly.
NOTE: It is recommended that a non-corrosive bead of silicone be applied before installation onto the
wall ensuring that no water can run down into the cabling.
Install the fitting onto the mounting bracket followed by the rubber seal, then secure by tightening the 2 nuts.
(Fig.3)
5. Install a globe (not included) into the lamp holder. Do not exceed the maximum wattage rating. (Fig.4)
6. Install the glass shade onto the fitting. Check the seal has not moved and forms a tight seal between the shade
and the lamp holder. (Fig.5)
