Imola
Luminaires
Valid for:
IMO 4550, IMO 4550 DIM, IMO 4550 SENSO
IMO 4551, IMO 4551 DIM, IMO 4551 SENSO
IMO 45520, IMO 45520 DIM, IMO 45520 SENSO
Assembly (free-standing luminaire)
A
Put stand-bottom (small guide slot) into base and tighten screw (5) properly.
B
Lead connecting cable (1) through the stand and carefully attach the light head on the stand. If necessary loosen screw (2)
slightly. Guide slot directs towards the front of the head. Fix the light head with the attached wrench.
C
Fix the connecting cable in the slot of the base.
Equip with light sources and operate according to following instructions.
2-Step Switch
The luminaire can be operated by push-button (3) in 2 modes (2 or 4 lamps).
Dimming
The luminaire can be dimmed by push-button (3). Press the push-button for a long
time, the luminaire increases or decreases the light. Brief pressing switches the lumi-
naire on or off. The previously set dimming value remains.
Sensor Control
Original-adjustment:
100% of light output.
Individual adjustment:
Put rocker switch (D) to position 1. Switch on the luminaire,
press briefly push-button (3). Set the desired lighting value on the push-button (3).
Press the push-button until the desired value is set. By pressing the push-button briefly
twice (push-button 3) the desired value is stored and the luminaire confirms by flashing
twice.
Switch-off automatic
In order to achieve an optimal energy consumption the luminaire is set on adaptive
delay during delivery.
The luminaire adapts itself automatically in relation to the frequency of presence and
absence. Therefore, no fixed values are programmed for switching-off. When the
luminaire is switched-off by the push-button (3), then the luminaire will return to auto-
matic operation after 30 minutes. Upon new movements the luminaire will switch on
when required. In case that a renewed switchting on after 30 minutes upon movements
is not desired (holiday mode) then the switch (D) is to be set on position 0 (luminaire is
cut off the mains).
Accessories
By means of the snap-on reflection ring (4) the acquisition field of the motion detector
can be focussed into a certain direction respectively enlarged by up to 5 m.
On the opposite side a limitation of the detection area is realized by means of the
attached reflection ring, as the picture below demonstrates.
Reflection ring (4)
Order-no. 872483
acquisition
field
enlarged
acquisition
Installation Instruction
970173
20.03.2007
#
$
A
B
C
D
(1)
(2)
(3)
(4)
(5)
