LSIS LSLV0055H100-4COFN, Руководство пользователя

Страница: 224 / 610

Learning Advanced Features
210
In the graph above, Pipe Break occurs if the feedback is smaller than the value caculated
by multiplying the two values set at PID-04 and PRT-61(PID-04 x PRT-61) at the inverter‘s
maximum output (when PID output is the maximum set value, or the inverter is running at
the frequency set at DRV-20).
5.20 Pre-heating Function
This function uses current to heat up the motor or pump to avoid the motor or the pump
freezing when they are not in operation.
Group Code Name LCD Display Parameter Setting Setting Range Unit
AP2
48
Initial heating
output current
Pre Heat
Level
20 1–100 %
49
Initial heating
output duty
Pre Heat
Duty
30 1–100 %
50
DC input delay
time
DC Inj Delay
T
60.0 0.0–600.0 sec
IN
65–
71
Terminal block
input
1–7
P1–7 Define 44 Pre Heat -
Initial Heating Setting Details
Code Description
AP2-48 Pre Heat
Curr
Sets the current to be used for initial heating. Sets the current to motor
no-load current % value.
AP2-49 Pre Heat
Duty
Sets the duty (time) for the current to be used for initial heating, from 10
seconds to % value.
AP2-50 DC Inj Delay
T
Sets a certain delay time to prevent from an over current trip that may
occur when a DC input is performed after the inverter Free-Run stop.
IN-65–71 P1–7
Define
Performs the Pre Heat function if the Pre Heat (44) terminal is set.
The initial heating function continually operates when the set multi-function input terminal is
on and until the inverter command is on. If an inverter command is input while the initial
heating function is operating, the inverter starts operation immediately.