LSIS LSLV0055H100-4COFN, Руководство пользователя

Страница: 134 / 610

Learning Basic Features
120
4.13 V/F (Voltage/Frequency) Control
Configure the inverter‘s output voltages, gradient levels, and output patterns to achieve a
target output frequency with V/F control. The amount of of torque boost used during low
frequency operations can also be adjusted.
4.13.1 Linear V/F Pattern Operation
A linear V/F pattern configures the inverter to increase or decrease the output voltage at a
fixed rate for different operation frequencies based on V/F characteristics. A linear V/F
pattern is partcularly useful when a constant torque load is applied.
Grou
p
Cod
e
Name LCD Display Parameter Setting Setting Range Unit
IN
09 Control mode Control Mode 0 V/F 0–1 -
18 Base frequency Base Freq 60.00 30.00–400.00 Hz
19 Start frequency Start Freq 0.50 0.01–10.00 Hz
BAS 07 V/F pattern V/F Pattern 0 Linear 0–3 -
Linear V/F Pattern Setting Details
Code Description
DRV-18 Base
Freq
Sets the base frequency. A base frequency is the inverter‘s output
frequency when running at its rated voltage. Refer to the motor‘s rating
plate to set this parameter value.
DRV-19 Start
Freq
Sets the start frequency. A start frequency is a frequency at which the
inverter starts voltage output. The inverter does not produce output voltage
while the frequency reference is lower than the set frequency. However, if a
deceleration stop is made while operating above the start frequency, output
voltage will continue until the operation frequency reaches a full-stop (0 Hz).