LSI ITI8000 Series, Руководство пользователя

Страница: 64 / 80

4-2 Configuring the Network Interface
Rev. 1.0 Copyright © 2000–2001 by LSI Logic Corporation. All rights reserved.
4.2 Configuring Host Files
After you install the ITI8241C-S adapter, you must create a
host
name.qfe<num>
file for each Ethernet interface. You must also assign
an IP address and a host name for each Ethernet interface in the
/etc/hosts
file.
To configure the host files, create an
/etc/hostname.qfe0
file. The
number 0 after .
qfe
represents the first Ethernet port of the qfe device.
Use channel qfe1 for a second Ethernet port and so on.
To ensure correct configuration of the host files, follow these points:
•
Do not create
/etc/hostname.qfe<num>
files for the qfe channels (if
any) you do not plan to use. The
/etc/hostname.qfe<num>
file must
contain the host name for the appropriate network interface.
•
The host name should have an IP address and should be entered in
the
/etc/hosts
file.
•
The host name should be different from any host name of any other
interface, for example:
/etc/hostname.qfe0
and
/etc/hostname.qfe1
cannot share the same host name.
•
The following is an example of the
/etc/hostname.qfe<num>
files
required for a machine called intra. This machine will be known as
intra-1 and intra-2 on the networks, which are connected to the qfe0
and qfe1 Ethernet interfaces.
intra # cat /etc/hostname.qfe0
intra-1
intra # cat /etc/hostname.qfe1
intra-2
intra # cat /etc/hostname.qfe2
intra-3
intra # cat /etc/hostname.qfe3
intra-4
Create an appropriate entry in the
/etc/hosts
file for each active qfe
channel.
intra # cat /etc/hosts
…