LSI ITI8000 Series, Руководство пользователя

Страница: 51 / 80

General Description 3-3
Rev. 1.0 Copyright © 2000–2001 by LSI Logic Corporation. All rights reserved.
Note 1: The output above represents an example. The output of the
show-devs
command varies depending on your system
and configuration. Use the corresponding entries on your
system, not the ones given here.
Note 2: If these devices are not listed, check that the adapter is
correctly installed and reseat the adapter.
3.1.2 Identifying the SCSI Disks
The
probe-scsi-all
command identifies the SCSI devices on your LSI
Logic adapter. To identify your SCSI disks, type at the
ok
prompt:
The system displays information similar to this:
If your system does not identify the SCSI disks on ITI8000 adapter,
check the following:
•
Does each disk have a unique SCSI ID?
•
Does each disk have a SCSI ID that does not conflict with the SCSI
ID of the ITI8000 adapter (Default id = 7)?
•
Is the bus correctly terminated? The TI8000 adapter automatically
terminates at the host end of the bus. You must have an SE/LVD
terminator at the end of the SCSI chain.
ok probe-scsi-all
/pci@1f,0/pci@1/pci@1/IntraServer,Ultra2-scsi@0,1
Target 0
Unit 0 Disk SEAGATE ST39102LC 0004
Target 1
Unit 0 Disk SEAGATE ST39102LC 0004
/pci@1f,0/pci@1/pci@1/IntraServer,Ultra2-scsi@0
Target 0
Unit 0 Disk IBM DDRS-34560D DC1B
Target 1
Unit 0 Disk IBM DDRS-34560D DC1B