LSI ITI8000 Series, Руководство пользователя

Страница: 25 / 80

Using the Network Installation Procedure 1-11
Rev. 1.0 Copyright © 2000–2001 by LSI Logic Corporation. All rights reserved.
1.5.4 Booting the Client using the ITHPS driver
Follow these steps to install the Solaris operating system on the client
target machine by using the boot/install server:
Step 1. Boot the network install kit by typing at the
ok
prompt:
ok boot net -v
Important: It is important to choose "Manual Reboot" rather than
"AutoReboot" during the Solaris installation on the target
machine. If you choose "AutoReboot", you will not have the
opportunity to complete the installation of the Ultra2 SCSI
driver and your system will fail to boot.
Step 2. Follow the prompts to complete the Solaris installation.
Step 3. Proceed to a console window and run the following script:
/sbin/itisinst
This script copies and installs the driver from the boot server to
the newly created Solaris installation. After this script has been
run, the Ultra2 SCSI device driver installation is complete.
Step 4. Reboot your system.
Notes: The message “major number maximum based on server,
not client” can safely be ignored.
Your Sun machine will prompt you to allow power saving
automatic shutdown. You must answer No to this question
if you are using the LSI Logic CompactPCI adapter to
support your boot disk.
If you change the disk drive configuration of your machine,
issue the command:
touch /reconfigure
and then reboot the system in order for the system to
detect and correctly install your new disks.