LSI ITI8000 Series, Руководство пользователя, Страница: 22 / 80

1-8 Installing the ITI8000 Series CompactPCI Adapters
Rev. 1.0 Copyright © 2000–2001 by LSI Logic Corporation. All rights reserved.
1.4.4 Distribution File Install
If you received the ITHPS driver in an
itis_install.tar.Z
file, follow
these steps:
Step 1. Uncompress and untar the
itis_install.tar.Z
file by
typing at the command prompt:
uncompress itis_install.tar.Z
tar -xvf itis_install.tar
cd install
This will create a directory named install.
Step 2. Start the installation by invoking the
pkgadd
command as:
pkgadd -d
The ITHPS device driver is now installed.
Step 3. Reboot the machine to reconfigure the system and to recognize
the new devices.
Note: If you change the disk drive configuration of your machine,
it may be necessary to issue the command:
touch /reconfigure
and then reboot the system in order for the system to
detect and correctly install your new disks.
1.5 Using the Network Installation Procedure
If you are using your ITI8000 adapters to support your Solaris SPARC
system disk, you must install the Solaris operating system using a
network install. This section describes a complete installation of Solaris
to a client system using the ITI8000 CompactPCI Ultra2 SCSI adapters
for the system disk. The method described in this section allows you to
install the LSI Logic ITHPS driver onto a network boot kit, which makes
it available during the Solaris SPARC installation script.
If you are simply installing an ITI8000 adapter as an additional storage
adapter in an existing system, use the driver installation procedure
described in
Section 1.4, “Installing the Ultra2 SCSI Drivers,” page 1-6 .