LSI ITI8000 Series, Руководство пользователя

Страница: 21 / 80

Installing the Ultra2 SCSI Drivers 1-7
Rev. 1.0 Copyright © 2000–2001 by LSI Logic Corporation. All rights reserved.
connected to the LSI Logic Ultra2 SCSI controller with support for Low
Voltage Differential (LVD) devices. This driver takes advantage of new
hardware features in the LSI53C896 controllers to minimize CPU
utilization, including a single interrupt per I/O.
As mentioned above, this driver allows connection of SCSI devices
including disk drives, CD-ROMs, and tape drives for PCI-based
machines. To support a new SCSI device, the Solaris architecture
requires that the device complies to the SCSI standard.
Note: If you plan on using an LSI Logic adapter for your System
Disk, you must use the Network install procedure in order
to load the device driver during installation.
1.4.3 Floppy Disk Install
To install the LSI Logic ITHPS driver to an existing Solaris system, you
must be logged into the root directory on your Solaris system. If you
received the ITHPS driver on a floppy diskette, follow these steps:
Step 1. Place the diskette in the floppy drive.
Step 2. Type at the command prompt:
volcheck
This command ensures that the system can see the floppy.
Step 3. Change the directory to the root directory of the floppy. For
example:
cd /floppy/floppy0
Step 4. Start the installation by invoking the
pkgadd
command as:
pkgadd -d.
The ITHPS device driver is now installed.
Step 5. Reboot the machine to reconfigure the system and to recognize
the new devices.