UNITOUR Power System
User Manual
Page 25
•
A channel that is on can be turned off by tapping that channel again.
“Solo” mode provides a fast method of identifying channels because the channel that you tap
will be the only channel that is on.
3.5.2
Solo Inactive
When “Solo is Inactive”, multiple channels can be turned on.
•
Tap a channel or press its
CHANNEL SELECT
button to turn it on. Switch and Relay
channel buttons turn green when on. Dimmer channel buttons turn blue when they
are on and the level of the selected channel (magenta) can be set by the fader at the
bottom of the screen.
•
Tap a
n “on” channel to turn it off.
If you
EXIT
Riggers Control without tapping
SAVE
, all channels under riggers control will be
released from its control.
To
EXIT
Riggers Control and maintain its current channel
“on” settings, tap
SAVE
. The home
screen “RIGGERS CONTROL” button changes to “RIGGERS ACTIVE”, telling
you that channel(s) are still turned on by the riggers control.
To release channels from Riggers Control, tap
RIGGERS ACTIVE
, then
EXIT
(without saving).
3.6
CHANNEL MODES
From the “Home Menu” tap
CHANNEL MODES
. The screen shows the current mode of each
channel.
To change the “Mode” of a channel, tap the channel to select it. Multiple channels can be
selected. A range of channels can be selected by tapping the
first channel
in the range then
THRU
then the
last channel
in the range. To de-select all channels tap
CLEAR
. When the
required channels are selected, tap a
”Mode” button at the bottom of the screen.
Channels can also be selected by pressing their
CHANNEL SELECT
button located above
each channel’s circuit breaker. Multiple channels can be selected. To select a range of
channels, press and
HOLD the first button
in the range then press the
last button
in the
range.
When a channel has been selected, the channel on the touch screen lights magenta and the
LED above the CHANNEL SELECT button on the output module lights magenta.
When no channels are selected you can tap any of
the “Mode” buttons at the bottom to identify
all of the channels that are set to the mode that you tap. The selected mode button and all of
the channels set to that mode (if any) will turn magenta.
Channel 1
is selected
Mode
Buttons
