LS ELECTRIC LSLV-S100 Series, Руководство пользователя, Страница: 65 / 270

Installing the Inverter
56
2.4
Test Run
After the post-installation checklist has been completed, follow the instructions below to test
the inverter.
1
Turn on the power supply to the inverter. Ensure that the keypad display light is on.
2
Select the command source.
3
Set a frequency reference, and then check the following:
• If V1 is selected as the frequency reference source, does the reference change
according to the input voltage at VR?
• If V2 is selected as the frequency reference source, is the voltage/current selector
switch (SW2) set to voltage, and does the reference change according to the input
voltage?
• If I2 is selected as the frequency reference source, is the voltage/current selector
switch (SW2) set to current, and does the reference change according to the input
current?
4
Set the acceleration and deceleration time.
5
Start the motor and check the following:
• Ensure that the motor rotates in the correct direction (refer to the note below).
•
Ensure that the motor accelerates and decelerates according to the set times, and
that the motor speed reaches the frequency reference.