LS ELECTRIC LSLV-H100 Series, Руководство пользователя

Страница: 315 / 618

302
Learning Advanced Features
Set on-delay and off-delay times separately to control the output terminal and relay
operation times. The delay time set at codes OUT-50
–51 applies to multi-function output
terminal (Q1) and relay, except when the multi-function output function is in fault trip mode.
Group Code Name LCD Display Parameter Setting Setting Range Unit
OUT
50
Multi-function output
On delay DO On
Delay
0.00 0.00
–100.00
sec
51
Multi-function output
Off delay DO Off
Delay
0.00 0.00
–100.00
sec
52
Select multi-function
output terminal DO NC/NO
Sel
000000* 00
–11
bit
*Multi-function output terminals are numbered. Starting from the right (number 1), the
number increases to the left.
Output Terminal Delay Time Setting Details
5.49 Operation State Monitor
Code Description
OUT-50
DO On Delay
When a relay operation signal (operation set in OUT 31
–35, 36) occurs, the
relay turns on or the multi-function output operates after the time delay set at
OUT-50.
OUT-51
DO Off Delay When relay or multi-function output is initialized (off signal occurs), the relay
turns off or multi-function output turns off after the time delay set at OUT-54.
OUT-52
DO NC/NO
Sel
Select the terminal type for the relay and multi-function output terminal. By
setting the relevant bit to ‘0,’ it will operate A terminal (Normally Open). Setting
it to ‘1’ will operate B terminal (Normally Closed). Shown below in the table are
Relay 1
–5 and Q1 settings starting from the right bit.
Item B terminal (Normal close) A terminal (Normal open)
Keypad
display