Tools and accessories
ProtoMat M60
25
6.0 Tools and accessories
6.1 Tools
The tools for the LPKF
ProtoMat
M60 come in two different lengths.
Tools used to machine the material surface (milling and engraving) are
36 mm long for 1/8" and tools used for drilling or contour milling are 38
mm long for 1/8" collets. The following tools are available.
fig. 7: LPKF tools for circuit board
plotters
Caution! Execute a tool change only in defined positions!
The tools must always be inserted in the tool fixture as far as they will
go. Otherwise the working depth will be incorrect. In certain
circumstances, this can even result in damage to the machine base
plate.
Tweezers are supplied for tool insertion and removal.
1
- Universal Cutter
for milling of isolation-canals and to the front
panel-engraving of 0,2-0,5 mm, according to
depth setting, length 36 mm.
2
- Micro Cutter:
for milling isolation channels of 0.1 - 0.2mm
(depending on the depth setting ), length 36mm
3
- End Mill (HF)
produces rectangular isolation channels of 0,15
mm, 0.25mm or 0,4 mm width, length 36 mm
4
- End Mill
for engraving of aluminums and to the milling of
wide isolations, different diameters, length 36
mm.
5
- Drill Bit
Cylindrical special tool to the drilling of base
material (reinforcedf), different diameters.
6
- Contour Router
to the contur routing of conductor plates as well
as molding machines of outbreaks, with chip
removal downward (downcutting), different dia-
meters, length 38 mm
7
- End Mill
to the contur routing as well as milling machine of
outbreaks in aluminums, HF-and microwave-
materials. Length 38 mm
