L-IP User Manual
20
LOYTEC
Version 6.1
LOYTEC electronics GmbH
Device Main Menu
================
[1] Show device information
[2] Serial firmware upgrade
[3] System configuration
[4] CEA-709 configuration
[5] IP configuration
[6] CEA-852 device configuration
[8] Reset configuration (factory defaults)
[9] Device statistics
[s] CEA-852 server configuration
[0] Reset device
Please choose:
Figure 7: Device Main Menu
Select ‘5’ from the device main menu and enter the IP address, netmask, and gateway
address. Note that you must use different IP addresses if you are using multiple IP devices
in your setup.
IP Configuration Menu
=====================
[1] DHCP : disabled
[2] IP Address : 192.168.1.33
[3] IP Netmask : 255.255.255.0
[4] IP Gateway : 192.168.1.1
[5] Hostname : LIP-3333ECTB-800000022E9F
[6] Domainname : <unset>
[7] DNS Servers : <unset>
[9] MAC Address : 00:0A:B0:01:32:B2 (factory default)
[0] NTP Servers : 0.pool.ntp.org 1.pool.ntp.org (out-of-sync)
[a] Connection Keep Alive : disabled
[b] Link Speed & Duplex : Auto Detect
[q] Quit without saving
[x] Exit and save
Please choose:
Figure 8: Enter basic IP settings.
Press ‘x’ to save the IP settings and reset the L-IP with the main menu item ‘0’ in order to
let the new IP settings take effect.
Important!
The default IP address 192.168.1.254 is only set for configuration access. It must be
changed in order to make the device functional.
You should now be able to add the L-IP to your IP-852 channel in the configuration server
member list. More detailed instructions can be found in Section 5.5.1. If the L-IP should
also act as the configuration server please proceed to Chapter 7.
3.2.2 Configuration via the Web-Interface
Optionally to using the console interface one can also use the Web interface to configure the
client device. In a Web browser enter the default IP address ‘192.168.1.254’ of the device.
Note that if your PC has an IP address in a subnet other than 192.168.1.xxx, please open a
command tool and enter the following route command to add a route to the device.
To Add a Route to the Device
1.
Windows
START
Run
2.
Enter ‘cmd’ and click
OK
.
3.
In the command window enter the command line