LOXONE INTERCOM XL
Part No.: 200192
Quick Start Guide
[A]
HARDWARE INSTALLATION
1.
This information is important for outdoor installation if
using the flush-mounted installation box! - The metal
edge of the box should be sealed against the surface
with the acrylic sealing.
The acrylic sealing must be applied to ensure that no
moisture can enter between the flush-mounted box and
the wall surface.
Additionally, the acrylic must be smooth so that the foam
rubber seal of the mounting frame is resting on an even
surface and no moisture enter in between the foamed
rubber seal and the flush-mounted box through any gaps.
2.
Power up the Loxone Intercom XL by connecting a
network cable with the delivered PoE injector. (Power
over Ethernet)
3.
Mount the camera on your backbox with the screws
included.
[B]
SOFTWARE SETUP
Upon initial start up, the Loxone Intercom will have the
following default settings.
SIP module:
IP-Address: 192.168.1.98
User: admin ; Pass: admin
Video module:
IP-Address: 192.168.1.99
User: admin
Once the Loxone Intercom XL has finished it’s boot up
procedures, please follow the steps below:
1.
Start Loxone Config and connect to your Miniserver
2.
Click on “Peripherals Search”
The search window will open as below:
3.
1 - Click on the “Network” tab.
This will display all devices found on your network.
(May take a view seconds)
2 - Click on Intercom Video or Audio
loxone.com
