Low Cost Mobility 250 GK83, Руководство пользователя, Страница: 18 / 24

18
MAINTENANCE
Lubrication
At six-month intervals you should lubricate the following parts with a multipurpose grease or similar
lubricant:
•
Seat pivot post.
•
Seat release lever pinion.
•
Clean and recoat axles lightly.
CAUTION – DO NOT USE WD40 TO LUBRICATE PARTS!! DO NOT LUBRICATE TRANSAXLE
GEARS!! In the event of any difficulties please consult your provider.
Wheels and Tires
The wheels of your scooter have split rims. This allows any punctures to be repaired easily.
To change the wheel remove the center 13 mm bolts and slide the wheel off its axle. Ensure that when
refitting the wheel the retaining bolt is fitted with a locking washer or the screw threads are treated with
lock-tite or a similar adhesive. When changing a tire the inner tube must be deflated. Remove the four
bolts from the wheel and split the rim. Tire pressure is recommended to be kept at 30 psi on the rear tires,
and 25 psi on the front.
General Scooter Maintenance
Every six months check the tiller base bolts, wheel axle bolts, and arm rest angle adjustment bolts and
tighten as necessary. Also check the seat and arm rest tightening knobs and tighten as needed.
TROUBLE SHOOTING GUIDE
Circuit Breaker
Your scooter is fitted with the latest in electronic controls that are programmed to protect the electrical
system from abnormal overloads. Fitted for extra protection is a circuit breaker, should there be a
situation that your scooter stops for no apparent reason please check that the circuit breaker has not
popped out or tripped. The circuit breaker can be found under the rear chassis cover accessible through a
port hole under the seat.
Check List
If your scooter fails to operate, please check the following:
•
Unit is switched on.
•
All plugs and connectors are firmly fixed.
•
Battery level shows full charge.
•
Freewheeling device is in the drive position (lever down).
•
Circuit breaker is reset.
•
Battery fuses are not blown.
If the free wheel device has been operated with the scooter switched on, then the scooter will not operate
until the ignition key has been switched off and then on again in order to reset the circuits.
Please consult your provider if your scooter does not run after checking these points.