Lovett’s Electronics warrants the LTH beeper to be
free from defects in materials and workmanship for a
period of one year. Lovett’s Electronics will promptly
repair or replace, as it deems most suitable, any
product which is defective in material or workmanship
without charge for parts and labor during the warranty
term of the original purchaser provided the product is
returned by the original purchaser to :
Lovett’s Electronics
840 E. Pinckley St.
Brazil, IN 47834
(812) 446-1093
All costs associated with the shipment of the
product are the responsibility of the original purchaser.
Please enclose $8.00 for shipping and handling and a
dated copy of receipt or cancelled check. This
warranty does not cover defects caused by improper
handling, maintenance or abnormal use, alterations or
accidents.
“Six-in-One” Beeper
INSTRUCTIONS & WARRANTY
INFORMATION FOR
LTH
Beeper Collar
Programming Instructions
After removing the battery, the
programmable switch is directly underneath.
The switch is labeled 1 through 8 with “on”
printed in the upper left hand corner.
To program, some will find it easier to put
all the switches in the off/down position. The
switches can be manipulated with a small
screwdriver, fingernail file, pocket knife or the
tip of an ink pen.
NOTE: The switches slide and not toggle or
rock.
The following list of codes, for example
“157” indicates switches 1, 5 and 7 are to be
in the on/up position. The remaining
switches will be in the off/down position.
When the switches are in this position(157)
the beeper will be in a regular dual mode with
a hawk scream for a point signal.
Codes for LTH
Dual Mode Regular
8 seconds between run
156
beeps and 8 second
delay to point beeps
Dual Mode Grouse
4 seconds between
13456
run beeps and 4 second
delay to point beeps
Point Only Regular
NO RUN SIGNAL and 8
256
second delay to point
beeps
Point Only Grouse
NO RUN SIGNAL and 4
23456
second delay to point
beeps
WARRANTY
The 8 switches all control a certain function of
the beeper. Switch 1 on and 2 off will give you a
dual mode. Switch 1 off and 2 on gives you point
only. Switch 3 controls the amount of delay to point
beep once the dog stops to either 4 or 8 seconds.
Switch 4 controls the time between run beeps to
either 4 or 8 seconds. These two switches, 3 and 4,
change the beeper from regular mode to grouse
mode. Switch 5 is in the up/on position anytime the
unit is programmed in dual or point only modes.
Switch 5 would be in the down/off position for run
only modes. Adding a hawk scream point signal is
done by switching 6 off and switching 7 on with any
of the above four codes. Switch 8 “on” gives you
two beeps in run and “off” gives you one beep.
Run Mode Only Regular
8 seconds between run
1
beeps regardless if dog
is moving or still
NO POINT SIGNAL
Run Mode Only Grouse
4 seconds between run
14
beeps regardless if dog
is moving or still
NO POINT SIGNAL
