15
8.5.3 SENSORS.
In this window, it is possible to confi gure the level sensor.
•
NUMBER OF BANKS.
This selection is necessary to set the number of the main bearings in which the engine is subdi-
vided.
•
SECOND BANKS CORRECTOR.
By setting the number of the main bearings on two, this item appears. On cars equipped with
two front lambda probes, this allows modifying (strengthening or weakening) linearly the GAS
carburetion concerning the second main bearings when the two main bearings work slightly un-
balanced.
In detail, by acting on this parameter, in case 4-cylinder cars the carburetion of the gas injectors
B and C is unbalanced with reference to that of the gas injectors A and D.
•
GAS LEVEL INDICATOR TYPE.
This indicates to the gas control unit what type of level sensor has been used:
LOVATO1050
- set LOVATO/AEB 1050 if to the gas control unit it is connected a
sensor with standard output signal LOVATO1050. For the connection
refer to the assembling diagram of the gas control unit.
LOVATO 526025
- set LOVATO if to the gas control unit it is connected a sensor with
standard output signal LOVATO1050. For the connection refer to the
assembling diagram of the gas control unit.
0 - 90 ohm
- set 0-90 ohm if to the gas control unit it is connected a sensor with
output signal ranging from 0 to 90 ohm. For the connection refer to
the assembling diagram of the gas control unit.
Not standard
- Set this option if it is connected a LPG or METHANE resistive sensor
with a variable STRAIGHT signal (lower value (Ohm) with empty level
and higher value (Ohm) with full level).
Not standard inverted
- Set this option if it is connected a LPG or METHANE resistive sensor
with a variable INVERTED signal (higher value (Ohm) with empty
level and lower value (Ohm) with full level).
References for the not standard indicator
- This option appears only if, in the box “TYPE OF
GAS LEVEL SENSOR” it is set NOT STANDARD
or NOT STANDARD INVERTED.
Set the reference values necessary for the setting
of the level sensor as follows:
- manually shift the indicator of the sensor star-
ting from the full value and write down the indi-
cated value for each reference (RESERVE, 1/4,
2/4, 3/4).
- enter the noted values in the corresponding bo-
