Operation Step Operation
Result
Illustration
Technical
data
Battery Specification: Li-ion Batter, 2000mAH, 7.4V.
Motor Torque/Speed: 1.1Nm/25rpm
Setup the
motor
Motor
assembly
1
A. Remove grease
protector ring by
opening the split
ring and sliding off
the motor body
B. Fit Crown by opening the
split ring and slide along the
motor body until it meets
the motor head
C. Fit the drive
using the circlip to
secure in position
D. Attached motor plate
with the screws supplied in
either left hand or right hand
orientation as required
Pairing
remote
transmitter
with motor
1
Hold down the
SETTING
button
on the motor
mount
Motor jogs 2 times
2
Please release this
button when the
motor jogs
3
Select channel for
blind and press the
CONFIRM
button
on the remote
within 10 seconds
Motor jogs 2 times. Remote
has now been paired with
the motor
Changing
motor
rotation
direction
1
Press
UP
button
If blind goes up the motor
direction is ok. If the blind
goes down then the motor
direction should be changed
2
Hold down
LIMIT
button and then
press
STOP
button
on the remote
transmitter
Hold both buttons until
motor jogs - at this moment
the motor rotation direction
has been changed
General Information
Illustration shows the side of motor head with
SETTING
button facing you.
• Motor antenna should be as straight as possible;
otherwise, the receiving distance will be reduced.
Remote
Transmitter
Motor
Remote
Transmitter
Motor
Press and hold
Release it
1
2
3
1
2
Issue: 1/15
®
Lithium Rechargeable Battery Motor
Instructions - 1100 Series
R1710 - Battery Motor
R1720 - 5 Channel Remote Control
