35
CODELOG MODE CONFIGURABLE PARAMETERS (continued)
Entry of Sensor Type values is as described below:
Temperature
1.
Set minimum temperature via:
Codelog > 1)Config > 6)Sensors > 3)Param > 1)C > 1)Min
2.
Set maximum temperature via:
Codelog > 1)Config > 6)Sensors > 3)Param > 1)C > 2)Max
3.
Set number of levels for temperature via:
Codelog > 1)Config > 6)Sensors > 3)Param > 1)C > 3)Level
Pressure
1.
Set the minimum pressure via:
Codelog > 1)Config > 6)Sensors > 3)Param > 2)PSI > 1)Min
2.
Set the maximum pressure via:
Codelog > 1)Config > 6)Sensors > 3)Param > 2)PSI > 2)Max
3.
Set the number of levels for pressure via:
Codelog > 1)Config > 6)Sensors > 3)Param > 2)PSI > 3)Level
Activity and Motion
The SRX1200 receiver may be configured for Activity or Motion. Selection
of the applicable setting will also depend on tag series/model
1
and
codeset selection . The Motion sensor state is transmitted and or logged in
a binary format, either active or inactive. Each Activity event
transmitted and or logged reflects either a maximum or mean value
of all the samples taken , e.g., 12Hz, 50Hz, 200Hz sampling rate, between
each tag transmission, or the maximum or mean value relative to the log
interval chosen to store Activity data. Activity level data are mapped
relative to the deflection and sensitivity scales for which the sensor
transmitters are programmed.
1.
Set the minimum activity via:
Codelog > 1)Config > 6)Sensors > 3)Param > 3)Act > 1)Min
This value is typically set to “0” (
inactive/not moving).
2.
Set the maximum activity via:
Codelog > 1)Config > 6)Sensors > 3)Param > 3)Act > 2)Max
This value is ty
pically set to “1” (
active/moving).
3.
Set the number of levels for activity via:
Codelog > 1)Config > 6)Sensors > 3)Param > 3)Act > 3)Level
1
The accelerometer-based 'Activity' option is specific to MCFT3-series transmitters.
