www.lorexbaby.com
BB2415AC1_Quick Start Guide_R1
Page 1
1-20022013
ADD-ON CAMERA
BB2415AC1
QUICK START GUIDE
x1
x2
x1
What’s Included
Getting Started
1
2
1
2
Make sure all power cables are at least 3ft / 1m
away from the crib and out of reach of your child.
Place the camera and monitor next to each other. Make sure the
camera and monitor are turned on.
Pairing the Camera with Your Monitor
Press and hold on your monitor until the screen looks like the
figure below.
Press to select the channel you would like to pair the
camera to.
NOTE:
If a camera is already connected to this channel, the new
camera will replace the existing camera.
3
Connect the power adapter to the camera and
then to a power outlet.
Slide the power switch
to ON.
Press on your monitor to begin pairing. The LINK LED
flashes to show that pairing mode is on.
4
5
Press the
PAIR
button on the bottom of the camera.
Video from the camera is immediately shown on the
monitor once the camera has been successfully paired.
PAIR
Use the included cable clips to help keep
power cords away from your child.
Cable clips
NOTE:
Immediately move the camera away from the
monitor to avoid speaker feedback.
TIP
C1
NOTE:
If pairing was unsuccessful, repeat steps 2 to 5
of the pairing process.
