13 |
L ’ O R S u p r ê m e
5. Descaling procedure
•
The descaling procedure (22 minutes) cannot be cancelled or interrupted after you have started it.
•
The water hardness entered during the initial set-up determines the descaling interval. If not entered
by the user, the machine is set to the highest water hardness by default.
•
The descaling interval is extended when a water tank filter is installed, see page 18 for exchange rate
and capacity.
Press the start button, and follow
the instructions shown in the
display.
Fill the water tank to Max.
level with hot water, and add the
descaling agent.
Open and close the lever to
ensure that there is no disc inside
the chamber.
Empty and clean the waste
bin, and reinstall it.
Remove the milk pack. Place the
milk tube in an empty 1 litre
container.
Place an empty 3 litre container
under the drink outlets.
The machine will start the
descaling program. (20 min.)
Caution:
very hot water is running
from the outlets.
The machine will thereafter
perform a rinsing cycle.
Please clean the water tank and
fill with fresh water.
The display shows ‘machine needs
rinsing’.
Press start and follow the
instructions shown in the display.
Wait until the rinsing process
is completed.
Remove the 1L container from the
fridge, and place the milk pack in
the fridge. (Put the tube in the
milk pack)
This concludes the descaling
program.
If there is not enough water in the
water tank during the descaling
process, a display message will
prompt you to refill the water
tank.
When done, the machine will
continue descaling.
