Looking Glass 8K
Stand Assembly
SAFETY
WARNING! Severe personal injury and property damage can result from
improper installation and assembly.
Read the following carefully before proceeding.
•
If you do not understand the instructions or have any concerns or questions,
please contact Looking Glass Factory.
•
DO NOT install or assemble if the product or hardware is damaged or missing.
If you require replacement parts please contact Looking Glass Factory.
•
This product is
ONLY intended for a Looking Glass 8K display - 51.8 lb /23.5kg
•
DO NOT use this product for anything other than the original design.
• Using this product with anything heavier than a Looking Glass 8K display
may result in instability causing possible injury.
•
DO NOT allow children to climb on or push the stand.
• This product contains moving parts, please use with caution.
•
ALWAYS use two (2) people when installing the Looking Glass 8K display onto
the stand.
•
ALWAYS use two (2) people when adjusting the height of the stand.
•
ALWAYS use two (2) people when moving the stand.
•
Looking Glass Factory disclaims any liability for the modifications, improper
installation, or installation other than the Looking Glass 8K display.
Hardware and tools provided
• M8x26mm socket head cap screw (SHCS) (4)
• M6x12 low profile socket head cap screw (4 +1 spare)
• M5x12mm pan head screw (2)
• M8x70mm shoulder bolt (4)
• M8 lock nut (4)
• Split washer (4)
• M6 washers (4 +1 spare)
• M4 hex key
• M6 hex key
Tools required
• Phillips screwdriver
• 1/2” / 13mm open head wrench
Instructions
1. Release the column from the base
• By hand, pull the double column out of its shipping
position in the base.
2. Install the casters
• Turn the base over bottom side up.
• Lock the casters.
• By hand install the four (4) casters with four (4) split
washers, by threading each into receptacles on the
base.
3. Install the double column
• Turn the base over and place with casters on the
ground.
• By hand insert the double column into the base.
Note: The vertical set of holes on the column should
face the back (narrow end) of the base.
Note: The small cross piece at the bottom of the
column must sit flush onto the base.
• Using the M6 hex key and the four (4) M8x26mm
SHCS screws, secure the column to the base plate.
X4
X4
X4
