Lonking LG833NG, Руководство пользователя

Страница: 73 / 134

73
CHAPTER IV OPERATION
4.1NOTICES ON OPERATION OF NEW LOADER
Even though each loader is properly inspected and adjusted before leaving the factory, it
is still necessary to abide by the following procedures during the running-in period,
otherwise the loader may get damaged or its performance may be reduced.
If the loader works under fully-loaded state before the expiration of the running-in period,
this will adversely affect the service life and safe operation, and finally cause fault.
NOTE:
1) Inspect whether the coolant, fuel, engine oil or hydraulic oil leaks every day.
2) Inspect the lubricating fluid every day and fill the lubricating fluid if necessary.
3) In the course of operation, pay attention to the instrument board and the indication of
various instruments from time to time.
4) Prevent the engine from getting overloaded.
5) Before the engine and other parts reach the operating temperature, remain the load
less than 80% of the rated load.
6) In the course of working, inspect whether the work attachment is normal.
7) Inspect whether any part is loosened or damaged owing to the transportation.
8) Inspect whether any wire or terminal is loosened, whether the instruments work
normally, and whether the electrolyte is sufficient.
4.2RUNNING-IN OF NEW LOADER
For a new loader, the running-in will play an important role in prolonging the service life of
the loader, eliminating hidden faults and avoiding the occurrence of serious fault. The user
shall carry out operation and maintenance in accordance with the provisions relating to
running-in of new loader as specified in this Manual after purchasing the loader, and then
the loader may be used normally.
4.2.1 REQUIREMENTS ON RUNNING-IN OF NEW LOADER
1. The running-in period for a new loader is 100 hours
2. After the engine is started up, make it run at idle speed for 5 minutes
3. During the running-in period, all the gears shall be arranged for running-in
respectively. When starting up the loader, the accelerator pedal shall be pushed down
smoothly and slightly, the speed shall then be increased gradually, and violent braking