Lonking LG833NG, Руководство пользователя

Страница: 126 / 134

126
Release the pin platen bolts of the bucket (1,
Figure 2), and then remove the bucket pin (2),
take out the pull bar or boom (3).
Remove the old O-ring, install the new O-ring (4,
Figure 3), and confirm that the O-ring on pull rod
or moving boom (3) groove has been cleaned.
Find out the pin hole and bucket pin hole, to
install the bucket pin (2, Figure 4).
Lock the Pin Plate bolts of Bucket (1, Figure 2).
5.15.2 REPLACEMENT OF THE BUCKET TOOTH
1 ． Start the engine, raise the bucket, and
arrange the pads under it, and put the bucket
flat on the pads, do not arrange too many
pads to make the bucket higher than the
height necessary for changing bucket tooth.
Engine turns off, pull the parking brake
button.
2. Dismount the pin off from the side of the clip
ring of the bucket teeth, remove the tooth kits
Figure 2
Figure 3
Figure 4