Operating instructions
ScanAfia X TK, S, ICU Version 1.5
Copyright © Lojer Oy, 2015
34
7.5 Operating the IV stand (60121, 60122)
IMPORTANT!
Check that there is enough room above the bed. When you
raise the bed, the IV stand raises with it.
IMPORTANT!
When you use the bed, note the stress on the IV stand and
the sleeve (Figure 75).
The IV stand is used to hold the infusion fluid and blood preparation bags in
intravenous rehydration treatments. The IV stand is installed into the sleeve at
the head of the hospital bed (see Figure 73). A standard of two IV stands can
be installed on the bed, additional sleeves for the foot of the bed are available
as accessories. The IV stand locks when the stand is put into the sleeve and
turned until a click sound is heard. The SWL of the IV stand is 2kg.
Figure 73.
The installation point and SWL label of the IV stand
The height of the IV stand is adjustable at the leg of the stand. Adjust the height
by pushing the adjustor piece up with your fingers and by moving the upper leg
of the IV stand. At the same time hold the lower leg of the IV stand so that it is
not disconnected from the bed.
Figure 74.
Adjusting the height of the IV stand
