11
Copyright © Lojer Oy, 2013
02/2013 Rev. 1.0
EASY TO CLEAN
DURABLE
LIGHT FAST
*Prescribed by law
Please follow the instructions of the respective manufacturer when using common cleaners.
Do not use oil or grease based solutions.
Do not use chemical or dry cleaning on the material.
The material is not resistant to solvents, chlorides, washing/polishing agents or aerosol sprays.
Colourings (by jeans or other textiles) are excluded from any guarantee.
For hygienic reasons cover the upholstery with protective cloth or paper.
Remove any stains as quickly as possible with lukewarm water and a damp cloth. Microfiber cloth is recommended for this
purpose. In case of heavy soiling, use a mild cleaning agent and soft brush.
Recommendable cleaning agent: Lojer Desiplint (1:10), which is effective against bacteria without drying the upholstery
material.
Repeat the cleaning procedure if necessary. (Composition of Lojer Desiplint: Chlorhexidine-digluconate 0,1
–
0,2 %, water 99,8
%.)
Use the recommended disinfectants (get matrix from [email protected]). Lojer cannot be held responsible for the effects of
other solutions than those mentioned in the matrix. Wipe the surface with a clean, damp cloth after disinfecting.
Dried substances or substances that have penetrated for an extended period may not be able to be removed completely.
5
Maintenance
Always unplug the power cord before service.
Only trained person may carry out service and repair. Maintenance carried out by an authorized person may
cause injury or damage to the device which the manufacturer is not responsible for.
All service and repair operations must be documented.
5.1
Biannual measures
Check the condition and functioning of following parts at least every six months.
Power cord and its fastening.
The wiring of the motors.
Controls and their wiring.
The fastening of the accessories.
The fastening of the castors. Proper functioning of the central locking.
Go through all adjustment and make sure that the table is working correctly.
Stop using the device if you notice any defects e.g. the device is making noise or functioning in sufficiently. Contact the service.
Only authorized personnel can open or change the actuator/control unit.
If some part of the device is damaged, detach the power cord and stop using the device. Contact the service.
