Console Operation
The mixIT is very easy to use. The console uses touchscreens to select sources and
bus assignments and knobs and buttons to adjust levels and turn faders on and off.
This gives the operator the best of both worlds: simple menus and fewer buttons
while still allowing someone to operate the board on air by feel without looking at
where their hands are going.
Fader Assignments
Any source can route to any fader. The sources are assigned during the setup
process using the Surface Settings menu in the web browser.
Tap the name of the source over the fader to change it. A list of choices appears.
Tap the arrow buttons to scroll through the list. Tap the name of the desired source
to route it to the fader. When you tap the source, the menu will close.
