Logitek mixIT Audio Console System/JET67 Manual
30
Under outputs, you can click on a DSP ouput to change the surface label of the mix bus. If you
want to change Program to instead read “WKRP Program” here’s your chance.
Mix Minus Tab
Figure 17 - The Mix Minus Tab
Click to edit each mix minus bus. On the mixIT, 12 mix minuses are avaliable.
How To Set Up A Mix Minus
A mix minus starts with a mix bus such as program, aux 1, aux 2, or aux 3 and subtracts certain
inputs from it. This is primarily used with remote broadcasts where there’s transport latency.
You want the person in the field to hear everything in the mix but themselves. This prevents an
echo coming back to the person in the field and making it difficult for them to talk.
The mixIT has 12 mix minus buses. You will tag the inputs, either local or network by editing
them and entering the mix minus number and saving it. Then here on the DSP settings page you
will define the mix minus bus and turn it on. Finally, you will route the output of the mix minus
bus either to a local or network output to feed your equipment.
Here is what to do on the DSP Settings Page:
•
Click on the line to edit the mix minus bus
