Logicube SCSI-NG, Руководство пользователя

Страница: 34 / 74

CLONING
Logicube SCSI-
NG User’s Manual
26
When cloning drives from a RAID configuration, the
Target drives may need to be initialized through the
computer’s RAID controller before being cloned to.
Clever – If clever is selected or used, the following settings are available:

Partition Resize – This screen will show the number of partitions found on the
Master drive and for each supported partition, a resize percentage setting will be
shown.
It is recommended that all System Restore, Recovery, and OEM
partitions should not be expanded. Setting the slider/percentage
to 0% will instruct the unit to keep the same partition size. The
percentage value, when set from 1 to 100 will determine what
percentage of the Target drive will be used. For example, setting
the percentage value to 100% would instruct the unit to use the
entire remainder of the Target drive for that partition.
4.4 Target
Tap the Target or Image File icon to select which drive will be used as the Target drive or which image
file will be used as the image. When Drive to Drive or Image to Drive is chosen from the Mode settings,
this will show the different drives connected to the unit. When Drive to Image is chosen from the Mode
settings, this will show the repository screen which contains the different images located on the unit’s
repository drive.
4.4.1 Selecting Target drive or images
If Drive to Drive or Image to Drive was chosen as the mode, the following screen will appear.
This will allow the selection of the Target. It will display any drive connected to the Target bay.