QUICK START
Logicube SuperSonix-
NG™ User’s Manual
18
Details on the different screens found in the Hash
operation can be found in
This mode will hash any connected drive on an active Master or Target port. This mode is Logical Block
Address (LBA) based and will hash drives based on the number of LBAs. If multiple drives are selected to
be hashed, the unit will hash up to the LBA value of the smallest capacity drive. If drives with different
capacities need to be hashed, it is recommended to start one task per drive.
3.2.1 Step-by-step instructions
–
Drive Hash
1.
Select
Hash
from the types of operation on the left side.
2.
Tap the
Target
icon and select the drive(s) to be hashed then tap the
OK
icon.
3.
Tap the
Settings
icon to choose the different settings based on the Mode. Details
for every setting can be found in
4.
Change any of the optional settings (LBA settings or percentage of the drive to
be hashed) if needed.
5.
Optional: Tap Job Info to set the Job Name, Job ID, Operator, Other ID, or Job
Notes.
6.
Tap the
Start
icon to start the hash task.
7.
When finished,
the status will show “COMPLETED”. At this point, it is
recommended to tap
Reset Task
to reset the task, so the drive bays properly
reset and not show as being used or assigned for other tasks.
