Installation Instruction
0482 Power Barrier
ENGLISH
Power Barrier for LogiCO2 Safety System.
Important!
Retain this instruction manual for future
reference: Please read these instructions
carefully prior to start-up and use. Failure to
follow any of these instructions could void
product warranties. LogiCO2 assumes no
responsibility for claims arising out of improper
or careless use or handling of it’s products.
Technical specifications
Power supply:
24V DC, from the alarm
system
Current consumption:
2 x 17 mA (Supply from
two v power supplies)
Humidity:
0-90%
non-condensing
Approval:
CE: Emission tests according
SS-EN 61000-6-3 and the
immunity tests according to
SS-EN
61000-6-2.
Ambient temperature:
0 to +40°C (+32°F to +102°F)
Dimensions (LxWxD):
90 x 161 x 38 mm /
3.5” x 6.3” x 1.5”
Ingress protection:
IP54 according to TÜV,
IP44 according to UL
Function
The LogiCO2 Power Barrier enables you to connect
multiple power supplies (up to eight) in one system.
Each power supply has an output of 1 A insuring that
the power limits are not exceeded on the cables and
connectors in each loop. The Power Barriers still
allows each separated sensor to communicate with
the Central Unit.
Power to the Power Barrier is supplied from the safety
system.
Indicators
The upper green LED indicates that the left cable is
connected to power. The lower green LED indicates
that the right cable is connected to power. Both LEDs
must be on for proper function.
Assembly
If the cover of the Power Barrier needs to be
removed, please observe the following order of screw
reassambling.
1
2
3
4
5
