These instructions are for the installation of our TRX-4 – Ascender Blazer body mount system. This will
allow you to mount an Ascender K5 Blazer body directly to your Traxxas TRX4 with minimal (if any)
modification to your TRX4. These instructions were created using a “Land Rover” TRX4 setup. You can
use the Bronco chassis & wheel wells but will need to sand for headlight buckets.
1. Remove font body mount posts.
Содержание TRX-4
Страница 2: ...2 Remove front body mount post support 3 Install new front body mount post support...
Страница 3: ...4 Install original Body mount posts into new body mount post support 5 Remove rear body mount posts...
Страница 4: ...6 Install new rear body mount posts 7 Body clip pin studs should be offset to the rear...
Страница 7: ......
