SCH Collectors Installation & Operation Manual
4
Collector Installation
(continued)
10. Position the collector onto the substructure (FIG. 4-26).
Figure 4-26 Position Collector On Substructure
ENSURE .2”
OVERHANG
POSITION COLLECTOR
ONTO SUBSTRUCTURE
11. Connect the collector to the bottom end brace using the
square disk and bolt provided in the kit (FIG. 4-27). Do
not
tighten.
12. Position the collector on the U-channels so that the
collector overhangs approximately 5 mm (.2") (FIG.
4-26). Tighten square disk.
13. Install the top end brace using the bolt provided in the
kit (FIG. 4-28).
14. Connect the collector to the end brace using the
square disk and bolt provided in the kit (FIG. 4-28).
15. Ensure all bolts are tightened.
Figure 4-28 Install Top End Brace
CONNECT COLLECTOR TO END BRACE
33
SCH Collectors Installation & Operation Manual
Figure 4-25 Lifting Rings
< 30°
6.5 ft.
< 30°
6.5 ft.
< 30°
6.5 ft.
< 30°
8.5 ft.
9. Ensure lifting rings are installed and spaced properly per
FIG.
4-25.
Figure 4-27 Connect Collector to Bottom End Brace
CONNECT COLLECTOR
TO BOTTOM END BRACE
HEX BOLT
SQUARE DISK
16. For
side by side installations
repeat Steps 1 - 15 and
install horizontal hydraulic connections (see FIG. 4-29).
Figure 4-29 Install Horizontal Hydraulic Connections
The Mechanical Connection Kit is an
optional kit available through the
manufacturer.
NOTICE
Only loosen the crane connection when
the collectors are completely fixed to the
substructure.
WARNING
