Lochinvar HERALD HCB116CE, Руководство по установке

Страница: 80 / 92

80
21.7 ANTI-CYCLING
21.7.1 A
NTI
-C
YCLING
T
IME
Once the burner turns off, a set amount of time must elapse before the control will respond to a new demand. The
control will block the new heat demand and anti-cycling will be shown in the display until the time has elapsed or the
water temperature drops below the Anti-Cycling Override Differential parameter. This parameter can be changed by
the installer by accessing the Anti-Cycling Time parameter. The time range for this parameter is 1 minute to 10
minutes. The default value is 1 minute.
21.7.2 A
NTI
-C
YCLING
O
VERRIDE
D
IFFERENTIAL
The control will bypass the anti-cycling time if the inlet water temperature drops too much. The control will use the
inlet water temperature present at the boiler when it shuts off as the starting point. If the inlet temperature drops
below the temperature parameter the control will abort anti-cycling and allow the boiler to fire. This parameter can
be changed by the installer by accessing the Anti-Cycling Override Differential parameter. The temperature range of
this parameter is 0°C to 30°C. The default value is 6°C.
21.7.3 R
AMP
D
ELAY
(E
NABLE
/ D
ISABLE
)
This parameter allows the installer to enable or disable the SH ramp delay. The default setting is disabled.
21.7.4 M
ODULATION
F
ACTOR
This parameter allows the installer to reduce the responsiveness of the temperature control function, for situations
where, for example, redundant heating capacity is installed. The values that are available are 40, 50, 60, 70, 80, 90,
and 100, with 100 being the most responsive. The default value is 100.