Lochinvar CP-M Series, Инструкции по установке, пусконаладке и обслуживанию

Страница: 4 / 94

4
1.0 INTRODUCTION

The Lochinvar CP-M+™ range is a wall hung gas-fired condensing boiler. The equipment comprises of stainless steel
radial burner assembly and heat exchanger that permits fully condensing operation.

The burner is initiated by a full electronic ignition sequence control that incorporates a spark ignition and a flame
rectification device for supervision of the flame.

The output from the boiler is regulated by a variable speed combustion fan and gas/air ratio controls to maintain the correct
combustion at all levels of modulation. This configuration allows modulation down to 25% of the rated output.

This equipment is intended for use on Group H Natural Gas (2
nd
Family) and LPG propane (3
rd
Family). The information
relating to propane firing is to be found in Section 15: LPG FUEL . This equipment MUST NOT use gas other than that for
which it has been designed and adjusted.

This equipment must be installed by a competent person, registered with a H.S.E. approved body. All installations must
conform to the relevant Gas Safety and Building Regulations. Health & Safety requirements must also be taken into
account when installing any equipment. Failure to comply with the above may lead to prosecution.

If the equipment is to be connected to an unvented (pressurised) system, care must be taken to ensure all extra safety
requirements are satisfied should a high or low-pressure condition occur in the system.

The equipment is designed for direct connection to a flue system.

Ancillary Options:
Item Description Part Number
1 Boiler Mounting Frame
E00-000-158
2 Boiler Mounting Frame E00-000-159
3 Boiler Mounting Frame E00-000-160
4 Boiler Mounting Frame E00-000-116
2 Boiler Gas/Flow/Return Manifolds CP-M+60 – CP-M+120 (R 1 ½”) E00-000-152
3 Boiler Gas/Flow/Return Manifolds CP-M+60 – CP-M+120 (DN65) E00-000-186
4 Boiler Gas/Flow/Return Manifolds CP-M+60 – CP-M+120 (DN80) E00-000-154
2 Boiler Gas/Flow/Return Manifolds CP-M+150 – CP-M+180 (DN65) E00-000-155
3 Boiler Gas/Flow/Return Manifolds CP-M+150 – CP-M+180 (DN80) E00-000-156
4 Boiler Gas/Flow/Return Manifolds CP-M+150 – CP-M+180 (DN100) E00-000-157
Interconnecting Pipework:
CP-M+60 – CP-M+120 E00-000-162
CP-M+150 – CP-M+180 E00-000-163
Low Velocity Header:
(R 1 ½”) E00-000-164
(DN65) E00-000-165
(DN80) E00-000-166
(DN100) E00-000-167
Calorifier Temperature Sensor E04-016-303
Cascade Flow Sensor (Required for cascade installations) E04-016-304
Outside Temperature Sensor E04-016-585
Pressurisation Unit
Floor standing – single pump LPU9000
Floor standing – twin pump LPU9001
Wall mounted – single pump CHCWM1
Wall mounted – twin pump CHCWM2
Condensate Neutralisation Kit KIT2000
Time, Temperature and Zone Control Refer to Section 11: ELECTRICAL SUPPLY
Flue System Components Contact Lochinvar Limited