7. Press the
System Mode
button. From there, press the
Main Menu
button in the top
right.
8. From the Main Menu screen, press
Initial Setting
, Communication I/F (
Comm. I/F
),
and then External IP Address (
Ext. IP Address
).
9. Ensure Ext. Device ID 0 is selected. From there, press the left/right arrow buttons to
select the item, and then enter the IP address with the numeric keys.
10. Press
SAVE
to save the settings
Changing the Smart Display IP Address
Modifying the Smart Display IP Address may break communication with the
sensor. The Smart Display IP cannot match the sensor’s IP and must be on the
same subnet, sensor default IP 192.168.1.10, subnet 255.255.255.0
1. Press and hold the top left corner of the smart display, above the word LENGTH for
3 seconds until a menu pops up
2. Press the system mode button. You will be taken to a screen that shows the current
IP address of the smart display. Press the
Main Menu
button in the top right.
3. From the Main Menu screen, press Initial Setting, Communication I/F (
Comm. I/F
),
and then Ethernet IP Address (
IP Address
). Press the left/right buttons to select an
item, then use the Keypad to enter the IP address and subnet mask values.
4. Press
SAVE
to save the settings.
Gocator Legal for Trade User Manual
27