GoMax Smart Vision Accelerator: User Manual
Introduction • 7
Element
Description
6
Maintenance category
Lets you upgrade firmware and perform a factory reset of the GoMax
unit. For more information, see
7
Status bar
Displays log messages from the GoMax unit.
The web interface on an accelerated sensor is identical to the interface on an unaccelerated sensor. The
Ethernet-based output protocols (Gocator, EtherNet/IP, ASCII, and Modbus) are also identical to those
found on an unaccelerated sensor, and are fully supported.
Estimated Scan Rates and Performance
Note that the estimates are based on tests done using Gocator firmware 5.2 SR1.
The following tables provide estimates of the scan rates of Gocator 3210, 3506, and 3504 under
different field-of-view and resolution settings.
For these estimates, the following settings were used:
l
Exposure was set to 4 milliseconds.
l
No measurement tools added.
l
Reduce Occlusion
and
Acquire Intensity
were disabled.
l
Uniform Spacing
was enabled.
Field of View
(X x Y x MR)
Spacing (mm)
Sensor-only (Hz)
With GoMax
(Hz)
100x154x110
0.5
6
10
100x154x110
0.2
1.8
10
100x154x110
0.1
0.5
4.7
100x154x110
0.08
0.3
4.0
100x154x110
0.05
0.15
2.1
Gocator 3210 Estimated Scan Rates
Field of View
(X x Y x MR)
Spacing (mm)
Sensor-only (Hz)
With GoMax (Hz)
30x45x25
0.2
4.3
8.5
30x45x25
0.1
3.2
8.5
30x45x25
0.02
0.2
2.7
Gocator 3506 Estimated Scan Rates